By ZJEST | 19 November 2022 | 0 Comments

Comprehensive knowledge of Led light maintenance

Most of the core components of LED lamps are composed of a driving power source and a light source. If the light is not on, there is a high probability that the light source will be broken down, resulting in dead lights or damage to the driving power source.

1.The light source is damaged

As shown in the figure below, there will be obvious burn marks "small black spots" in the middle of the broken down LED light source. If this kind of situation occurs, buy a patch with corresponding power to install it to solve the problem.



2.The driver power supply is damaged If there is no trace of damage to the light source, there is a high probability that the driver is damaged. You can replace the driver with a matching one according to the mark on the original driver. Please check the parameters of the original driver power supply when purchasing the driver power supply, especially the power range and output current.

3.
Three color dimming patch replacement
If the three-color dimming patch only lights up a group of single white light or single warm light, there is a high probability that the light source is damaged. If all are not bright, it is mostly the damage of the driving power supply, because the three-color patch can not change one group of light source, if the damage of a group of only the whole replacement. Trichromatic light source and drive are three lines, a negative pole common, two positive poles respectively control two groups of light sources.


4.maintenance of lamps with section switch This situation mostly appears in the lamps with multiple groups of light sources, such as a lamp with its own LED light source, lamp head or the number of light sources need to be controlled separately, if the multiple groups of light sources are not bright at the same time, the high probability is the subsection switch damage. Maintenance method: 1. First, take off a group of light sources from the segment switch for power-on test. If the lights are on, there is a high probability that the segment switch is damaged. 2, also can not be segmented switch, such as the original multiple groups of switch line can be grouped, such as only a group of switch line, you can put all groups into a group. If you don't know how to connect, you can direct me.

Leave a Reply

Your email address will not be published.Required fields are marked. *
Name
E-mail
Content
Verification code
ver_code